Please contact us first using the form below and we will arrange an introduction meeting. During the introduction meeting we will discuss your requirements and wishes and present our chamber in more detail. On this basis we will prepare an offer for you. The measurements will start when all necessary components are delivered. After the measurements, we will arrange another meeting to review the results and agree on additional analyzes. At the end you will receive the results in the form of a report.

If your numerical model describes the operation under the conditions achievable in our test chamber, validation is possible. For further information please contact us using the form below.

It is difficult to talk about the price in general, as it depends on several different parameters (operating conditions, number of measurements, type of control). For more information, please contact us using the form below.

The measured device/appliance would be equipped with sensors via data acquisition system (National Instruments)  that can continuously collect and display data on a computer belonging to the measuring system. For further information please contact us using the form below.

The total duration of the measurements depends on several factors, such as the supply of the components, the setting of the test bench, the adaptation of the data output, etc. The duration of a measurement depends on your requirements or specific tests: it may take a few minutes or a few days. In the case of three fans, the measurements are performed separately for each fan. For further information, please contact us using the form below.